A novel technique of dynamic speed control for buck boost converter fed BLDC motor drive

 
 
 
  • Abstract
  • Keywords
  • References
  • PDF
  • Abstract


    This paper mainly impacts on a bridgeless buck boost converter fed Brush Less Direct Current (BLDC) motor drive with Power Factor Correction (PFC) which is low cost and well suitable for low power applications. The speed of the BLDC motor is controlled by adjusting the Voltage Source Inverter’s dc link voltage which is then employed along with a distinct voltage sensor. Thus the fundamental frequency switching of VSI operation becomes quite ease with BLDC motor’s electronic turn off which provides minimal switching losses. An acceptable performance is attained for speed control having power quality indicators within the allowable limits. To end with the suggested drive’s prototype model has been implemented to evaluate and confirm the suggested BLDC motor drive’s performance for various speed controls with enhanced AC main’s power quality.

     


  • Keywords


    Bridgeless Brush less Direct Current (BLDC), Voltage Source Inverter (VSI), Power Factor Correction (PFC).

  • References


      [1] Xia CL, Permanent Magnet Brushless DC Motor Drives and Controls. Hoboken, NJ, USA: Wiley, (2012).

      [2] Moreno J, Ortuzar ME & Dixon JW, “Energy-management system for a hybrid electric vehicle, using ultra capacitors and neural networks”, IEEE Trans. Ind. Electron., Vol.53, No.2, (2006), pp. 614–623.

      [3] Chen Y, Chiu C, Jhang Y, Tang Z & Liang R, “A driver for the single phase brushless dc fan motor with hybrid winding structure”, IEEE Trans.Ind. Electron., Vol.60, No.10, (2013), pp.4369–4375.

      [4] Huang X, Goodman A, Gerada C, Fang Y & Lu Q, “A single sided matrix converter drive for a brushless dc motor in aerospace applications”, IEEE Trans. Ind. Electron., Vol.59, No.9, (2012), pp.3542–3552.

      [5] Toliyat HA & Campbell S, DSP-Based Electromechanical Motion Control. Boca Raton, FL, USA: CRC Press, (2004).

      [6] Pillay P & Krishnan R. Modeling of permanent magnet motor drives”, IEEE Trans. Ind. Electron., Vol.35, No.4, (1988), pp.537–541.


 

View

Download

Article ID: 12169
 
DOI: 10.14419/ijet.v7i2.21.12169




Copyright © 2012-2015 Science Publishing Corporation Inc. All rights reserved.