Improving the Quality of High Density Polyethylene Pipes using Design of Experiments

 
 
 
  • Abstract
  • Keywords
  • References
  • PDF
  • Abstract


    The purpose of this work is to study quality related problems in polyethylene pipe products and to improve their quality. Design of Experiment methodology will be used in order to find the optimum settings of the production processes parameters and to reduce the defects. Based on data collected and after the analysis the significant factor is haul off speed, interaction between screw speed and temperature and interaction between screw speed and haul off speed. The results show that the optimum run was operating at high level off haul of speed and
    low level of screw speed and temperature, this run most of the samples that produced are match to the customers’ specification.


  • Keywords


    Full Factorial Design; Polyethylene Pipes; Extrusion; Quality Improvement; Case Study

  • References


      [1] Kandar, MI Mat, and H. M. Akil., ”Application of design of experiment (DoE) for parameters optimization in compression moulding for flax reinforced biocomposites.” Procedia Chemistry 19 (2016): 433-440.

      [2] Krishnaswamy, Rajendra K., ”Analysis of ductile and brittle failures from creep rupture testing of high-density polyethylene (HDPE) pipes.” Polymer 46.25 (2005): 11664-11672.

      [3] A. Omar, H. Barhoosh, N. Ali, and S. Haskaykeh, High Density Polyethylene Pipes Quality Improvement, An-Najah National University, BSc. Thesis, (2013)

      [4] Montgomery, Douglas C., Design and analysis of experiments. John wiley and sons, (2017).

      [5] Kalpakjian, Serope, K. S. Vijai Sekar, and Steven R. Schmid. Manufacturing engineering and technology. Pearson, 2014.

      [6] Kang, J. S., S. J. Stuart, and J. S. Davidson., ”Analytical evaluation of maximum cover limits for thermoplastic pipes used in highway construction.” Structure and Infrastructure Engineering 9.7 (2013): 667-674.

      [7] Kiass, N., et al., ”Experimental approach to mechanical property variability through a high-density polyethylene gas pipe wall.” Journal of applied polymer science 97.1 (2005): 272-281.

      [8] Roy, Ranjit K., ”Design of experiments using the Taguchi approach: 16 steps to product and process improvement.”, John Wiley and Sons, 2001.

      [9] Kirk, Roger E., ”Experimental designs: An overview.” Experimental Design: Procedures for the Behavioral Sciences, 3rd edition. Pacific Grove, California, Brooks-Cole (1995): 37-40.


 

View

Download

Article ID: 25609
 
DOI: 10.14419/ijet.v7i4.25609




Copyright © 2012-2015 Science Publishing Corporation Inc. All rights reserved.