Multiple Fault Detection, Classification and Location in Electric Power Transmission Lines in Matlab Environment

  • Authors

    • Dr. Afaneen anwar
    • Rana Ali Abttan
    2018-11-27
    https://doi.org/10.14419/ijet.v7i4.16.21790
  • Multiple faults, multiple fault analysis, fault on transmission line, multiple fault detection, multiple fault type classification, multiple faults location
  • Multiple faults is one of the most difficult and an undesired problems of faults indicates that involving two or more faults at the same time in different places on a balanced electric network. The main objective of multiple faults detection, classification and location is satisfy accelerates line restoration, maintains system, stability, repairs the fault, decreases the restoration time and increases the system reliability.

    In this paper, the problem of multiple faults detection and diagnosis was studded and analyzed, including fault analysis, detection, classification, and fault sites locating using conventional method. In the first stage the system was analyzed using the conventional method to obtain the voltage and current values to extract the required characteristics of the units. In the second stage, the faults were detected by a comparison between the voltage and current values before and after the fault. In the third stage, faults were classified according to fault conditions. In the fourth stage, fault locations were identified by impedance base method for different types of fault and places were to estimation accurately fault location by analyzing the data available after the beginning of disturbance.

    All programs were written in MATLAB environment. The programs were test on IEEE- 11 bus bar network. The results clarified that the conventional method is very effective for multiple faults detection, classification and location. Analyzing this network highlights some of the dangers regions in the system.

     

     

  • References

    1. [1] D. Beeman, " Industrial Power Systems Handbook", McGraw-Hill, (A book), 1955.

      [2] J. Lewis Blackburn, Protective Relaying Principles and Applications, Second Edition

      [3] Charles A. Gross, “Fault Calculations in Power Systems Subject to Multiple Faults,†IEEE Trans. on Power Delivery, pp. 598 – 601, 1990.

      [4] D M Gilbert and I F Morrison,'' A statistical method for the detection of power system faults'', Electrical Power & Energy Systems, Vol. 19, No. 4, pp. 269-275, 1997.

      [5] Dalsten, B.Kulicke : "Neural Network Approach to Fault Type Classification For High Speed Protective Relaying" , IEEE Transactions On Power Delivery , vol. IO , No. 2 , April 1995 .

      [6] T. Takagi,Y. Yamakoshi, M. Yamaura, R. Kondow and T. Matsuskima, "Development of a New Type Fault Locator Using The One-Terminal Voltage and Current Data", IEEE Transactions on Power Apparatus and Systems, Vol. PAS -101, No. 8, , pp. 2892 -2897,August 1982.

      [7] Jenifer Mariam Johnson, Anamika Yadav ,''Complete protection scheme for fault detection, classification and location estimation in HVDC transmission lines using support vector machines'', IET Science, Measurement & Technology, 2017, Vol. 11 Iss. 3, pp. 279-287

      [8] K.R. Krishnanand, P.K. Dash and M.H. Naeem," Detection, classification, and location of faults in power transmission lines", Electrical Power and Energy Systems 67, pp. 76–86, 2015 .

      [9] Qais H. Alsafasfeh, Ikhlas Abdel-Qader, Ahmad M. Harb," Fault Classification and Localization in Power Systems Using Fault Signatures and Principal Components Analysis" , Energy and Power Engineering, 4, pp.506-522, 2012.

      [10] Thompson Adu "A New Transmission Line Fault Locating System " ,IEEE Transactions on Power Delivery, Vol. 16, No. 4,October 2001.

      [11] FAN Chunju ,DU Xiuhue, LI Shengfang, “An Adaptive Fault Technique Based on PMU for Transmission Line†,IEEE Power Engineering Society General Meeting , pp. 1 - 6 ,2007.

      [12] A. Recioui, B. Benseghier and H. Khalfallah,'' Power System Fault Detection, Classification and Location Using the K- Nearest Neighbors'', IEEE International Conference on Electrical Engineering ,pp.1– 6,2015.

      [13] Hadi Saadat, ''Power System Analysis'', McGraw-Hill International Editions, Book, 1999.

  • Downloads

  • How to Cite

    Afaneen anwar, D., & Ali Abttan, R. (2018). Multiple Fault Detection, Classification and Location in Electric Power Transmission Lines in Matlab Environment. International Journal of Engineering & Technology, 7(4.16), 111-119. https://doi.org/10.14419/ijet.v7i4.16.21790