Design and Analysis of Modified Diode Rectifier Circuit Suitable for Piezoelectric Energy Harvester for Biomedical Applications

  • Authors

    • S S. Dhayabarasivam
    • K Jayanthi
    • Gouthame Pragatheeswaran
    2018-07-26
    https://doi.org/10.14419/ijet.v7i3.16.16185
  • Energy harvesting, Rectifier, Converter, Piezoelectric
  • Abstract

    Nowadays renewable energy sources play a significant role in the energy harvesting. For the past decade various energy harvesting methods have been discussed by researchers for capturing the energy from different sources. From the survey, one of the most prominent methods is the use of piezoelectric transducers for harvesting the energy. It is known that piezoelectric energy harvesting is the easiest method of energy harvesting from the various sources available such as human walking, dancing etc. Therefore this method can be implemented in system for wide variety of applications. The piezoelectric transducer AC output is of very low voltage and power and hence insufficient to drive any electrical application. Most of the small scale electrical application generally runs on the DC voltage, therefore the AC voltage obtained from the piezo transducer vibration is rectified using rectifiers to generate DC voltage. Thus in this paper, a modified rectifier AC/DC converter with the combination of an inductor is placed in the rectifier, which enhances the voltage and power from the rectifier output. In order to enhance the voltage rating, a DC/DC converter has been added at the end of a rectifier circuit. From the simulation results the proposed circuit modified rectifier has improved the output voltage as well as output current by 10.19 volts and 0.1019 amps respectively for input voltage of 5V. When compared with conventional rectifier circuit.

  • References

    1. [1] S.P. Beeby, D.Zhu (2015). Vibration energy harvesting: fabrication, miniaturization and applications. SPIE Microtechnologies, Barcelona, ES.8.

      [2] K A Cook-Chennault, N Thambi and A M Sastry (2008). Powering MEMS portable devices- a review of non- regenerative and regenerative power supply systems with special emphasis on piezoelectric energy harvesting system, Smart Material Structure.1.7, 1-33.

      [3] Faurk Yilidz (2011). Energy harvesting from passive human power, Journal of applied science and engineering technology issue 4.

      [4] S.Lu, F.Boussaid (2015). A Highly efficient P-SSIH rectifier foe piezoelectrci energy harvesting. IEEE Transactions on power electronics 30(10). 53645369.

      [5] Y. Kushino, H. Koizumi (2014). Piezoelectric energy harvesting circuit using full wave voltage doubler rectifier and switched inductor. IEEE Energy conversion congress and exposition (ECCE), Pittsburgh, PA. 2310-2315.

      [6] Y. Sun, I.Y. Lee, C.J. Jeong, S.K. Han, S.G. Lee (2011). An comparator based active rectifier for vibration energy harvesting systems. 13th Inter. Conf. on Advanced Communication Technology (ICACT), Seoul. 1404-1408.

      [7] G.K. Ottman, H.F. Hofmann, A.C. Bhatt and G.A. Lesieutre (2002). Adaptive piezoelectric energy harvesting circuit for wireless remote power supply. IEEE Trans. Power Electron, vol.17, no.5, pp.669-676.

      [8] G.K. Ottman, H.F. Hofmann, A.C. Bhatt and G.A. Lesieutre (2003). Optimized piezoelectric energy harvesting circuit using step-down converter in discontinuous conduction mode. IEEE Trans. Power Electron, vol.18, no. 2, pp. 696-703.

      [9] J.R. Liang and W.H. Liao (2009). Piezoelectric energy harvesting and dissipation on structural damping. J.Intell. Mater.Syst. Struct. Vol. 20, no.5, pp. 515-527.

      [10] Jinhaoqiu, Haojiang, Hongliji, Kongjumzhu (2009). Comparison between four piezoelectric energy harvesting circuits. Front. Mech.Eng.China, 4(2). pp. 153-159.

      [11] A. Tabesh and L.G. Frechette (2010). A low power stand-alone adaptive circuit for harvesting energy from a piezoelectric micro power generator. IEEE Trans. Ind. Electron. Vol.57, no.3, pp. 840-849.

      [12] S. Roundy, P.Wright and J.Rabaey (2003). Energy scavenging for wireless sensor networks with special focus on vibrations. Boston, MA. Kluwer Academic.

  • Downloads

  • How to Cite

    S. Dhayabarasivam, S., Jayanthi, K., & Pragatheeswaran, G. (2018). Design and Analysis of Modified Diode Rectifier Circuit Suitable for Piezoelectric Energy Harvester for Biomedical Applications. International Journal of Engineering & Technology, 7(3.16), 67-70. https://doi.org/10.14419/ijet.v7i3.16.16185

    Received date: 2018-07-24

    Accepted date: 2018-07-24

    Published date: 2018-07-26