A Compact Multi-band Rectangular Slot Microstrip Antenna for Wi-MAX, WLAN and X-band Applications

Authors

  • Banuprakash R
  • Hariprasad. S.A

DOI:

https://doi.org/10.14419/ijet.v7i3.12.15872

Published:

2018-07-20

Keywords:

Ttrippleband, slot. HFSS, WLAN, WiMAX

Abstract

In this paper a rectangular slotted rectangular patch tripple band antenna for wireless applications is presented. The antenna has dimension of about 25 x 20 x 1.6mm3. The antenna operates at the frequencies 3.6 GHz, 5.8 GHz and 7.5 GHz with bandwidth of about 3.61%, 1.03% and 1.07% respectively. This antenna can be used for WIMAX (3.6GHz), WLAN (5.8GHz) and X-band(7.5GHz) applications. The stable radiation pattern, acceptable gain and good impedance matching are observed at obtained frequencies using HFSS tool.

 

 

References

[1] Abdelheq Boukarkar, Xian Qi Lin, Yaun Jiang, and Yi Qiang Yu, Miniaturized single-feed multiband patch antennas, IEEE, 2017.

[2] Muhammad Salim Garba and Hong-Xing Zheng, Analysis and design of compact multiband patch antenna for wireless application, Institute of antenna and microwave techniques, Tianjin university of technology and education, IEEE, 2016.

[3] Indu Jiji Rajmohan and M. I. Hussein,A multiband planar antenna design using hexagonal patch and a resonator slot, UAE University, IEEE, 2016

[4] S. A. H. Saghanezhad and Z. Atlasbaf, Miniaturized dual-band CPW-fed antennas loaded with U-shaped metamaterials, IEEE, 2016.

[5] M. Li, X.Q. Li, J. Y. Chin, R. Liu and T. J. Cui, A novel miniaturized printed planar antenna using split-ring resonator, IEEE, 2008.

[6] S. M. Aguilar, M. A. Al-Joumayly, M. J. Burfeindt, N. Behdad, and S. C. Hagness, Multiband miniaturized patch antennas for a compact, shielded microwave imaging array, IEEE, 2014.

[7] C. A. Balanis, Antenna Theory: Analysis and design. Hoboken, NJ, USA: Wiley,2005, p.811.

View Full Article:

How to Cite

R, B., & S.A, H. (2018). A Compact Multi-band Rectangular Slot Microstrip Antenna for Wi-MAX, WLAN and X-band Applications. International Journal of Engineering & Technology, 7(3.12), 108–111. https://doi.org/10.14419/ijet.v7i3.12.15872

License

Authors who publish with this journal agree to the following terms:

    1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution Licensethat allows others to share the work with an acknowledgement of the work''s authorship and initial publication in this journal.

    1. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal''s published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.

  1. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
Received 2018-07-19
Accepted 2018-07-19
Published 2018-07-20