Selection of alternative material for common rail direct injection system
About this article
DOI:
https://doi.org/10.14419/ijet.v3i2.1810Abstract
Common rail direct fuel injection is a modern variant of direct fuel injection system for petrol and diesel engines. The common rail system prototype was developed in the late 1960s by Robert Huber of Switzerland and the technology further developed by Dr. Marco. In petrol engine MPFI technology was developed and implemented in earlier days. Basically common rail tube was fabricated by steel for petrol engines. In the current study Steel, Brass, Aluminum alloy a356 and ABS materials were analyzed separately and aluminum is found the best material among the steel, brass and ABS material for common rail injection tube.
Keywords: Common Rail Injection System, Alternate Material.
References
Borghi M., Milani M., Piraccini M. (2001), Dynamic Analysis of Diesel Engine Common Rail Injection System. Part I: Inejctor Dynamics, In: Proceedings of 2OOl ASME lnternational Mechanical Engineering Congress and Exposition, IMECE2001/FPST-25001
Catania A.E., Dongiovanni C., Mittica A., Negri C., Spessa E. (1999), Simulation and Experimental Analysis of Diesel Fuel-Injection Systems With a Double-Stage Injector, In: Transactions of the ASME - Journal of Engineering for Gas Turbines and Power, Vol. l2l, pp. 186-196
Contore G., Mattarelli E., Boretti A.A. (1999), Experimental and Theoretical Analysis of a Diesel Fuel Injection System, In: SAE lnternational SP-l4l5, paper 1999-01-0199
Wickman D.D., Senecal P.K. Reitz R.D. (2001), Diesel Engine Combustion Chamber Geometry Optimization Using Genetic Algorithms and Multi-Dimensional Spray and Combustion Modeling, In: Proc. of the SAE 2OOl World Congress, paper 2001-01-0547
Hiroyasu H., Kadota T., Arai M. (1983), Development and Use of a Spray Combustion Modeling to Predict Diesel Engine Efficiency and Pollutant Emissions, In: Bulletin of the JSME, Vol. 26, Nr. 214, pp. 569-575
View more references (1)
Barba C., Burkhardt C., Boulouchos K., Bargende M. (2000), A Phenomenological Combustion Model for Heat Release Rate Prediction in High-Speed DI Diesel Engines with Common Rail Injection, In: SAE lnternational, paper 2000-01-2933.