An experimental investigation of heat transfer characteristics of water based Al2O3 nanofluid operated shell and tube heat exchanger with air bubble injection technique

  • Authors

    • Gaurav Thakur Chandigarh University
    • Gurpreet Singh Chandigarh University
    2017-09-16
    https://doi.org/10.14419/ijet.v6i4.7881
  • Shell and Tube Heat Exchanger, Al2O3/Water Based Nanofluids, Heat Transfer Coefficient, Overall Heat Transfer Coefficient, Nusselt Number.
  • The thermal performance of shell and tube heat exchangers has been enhanced with the use of different techniques. Air bubble injection is one such promising and inexpensive technique that enhances the heat transfer characteristics inside shell and tube heat exchanger by creating turbulence in the flowing fluid. In this paper, experimental study on heat transfer characteristics of shell and tube heat exchanger was done with the injection of air bubbles at the tube inlet and throughout the tube with water based Al2O3 nanofluids i.e. (0.1%v/v and 0.2%v/v). The outcomes obtained for both the concentrations at two distinct injection points were compared with the case when air bubbles were not injected. The outcomes revealed that the heat transfer characteristics enhanced with nanoparticles volumetric concentration and the air bubble injection. The case where air bubbles were injected throughout the tube gave maximum enhancement followed by the cases of injection of air bubbles at the tube inlet and no air bubble injection. Besides this, water based Al2O3 nanofluid with 0.2%v/v of Al2O3 nanoparticles gave more enhancement than Al2O3nanofluid with 0.1%v/v of Al2O3 nanoparticles as the enhancement in the heat transfer characteristics is directly proportional to the volumetric concentration of nanoparticles in the base fluid. The heat transfer rate showed an enhancement of about 25-40% and dimensionless exergy loss showed an enhancement of about 33-43% when air bubbles were injected throughout the tube. Moreover, increment in the heat transfer characteristics was also found due to increase in the temperature of the hot fluid keeping the flow rate of both the heat transfer fluids constant.

  • References

    1. [1] Kahrom, M., Haghparast, P. and Javadi, S.M. (2010) Optimization of heat transfer enhancemnt of flat plate based on pereto genetic algorithm, International Journal of Engineering, Transaction A: Basics, 23, 177-190.

      [2] Ahmadzadehtalatapeh, M. and Yau, Y.H. (2012), Energy conservation potential of heat pipe heat exchanger: Exprimental study and predictions, International Journal of Engineering Transection B: Applications, 25, 193-199.

      [3] Cancan, Z., Yafei, L., Li, W., Ke, X. and Jinxing, W., (2014), Review heat exchanger: Research development of self-rotating inserts in heat exchanger tubes, International Journal of Engineering-Transactions A: Basics, 27, 15-26.

      [4] Saleh K, Abdolrahman D, (2017), Effect of air bubble injection on the performance of a horizontal helical shell and coiled tube heat exchanger, Applied Thermal Engineering, 111, 676–683. https://doi.org/10.1016/j.applthermaleng.2016.09.101.

      [5] Celata, GP, Chairadia, A, M. Cumo and F.D. Annibale, (1999), Heat transfer enhancment by air injection in upward heated mixed convection flow of water, International Journal of Multiphase Flow, 25, 1033-1052. https://doi.org/10.1016/S0301-9322(99)00059-2.

      [6] Dizaji, HS. and Jafarmadar, S. (2014), Heat transfer enhancement due to air bubble injection into a horizontal double pipe heat exchanger, International Journal of Automotive Research, 4, 902-910.

      [7] Gabillet, C, Colin, C., Fabre, J., (2002) Experimental study of bubble injection in a turbulent boundary layer, International Journal of Multiphase Flow, 28, 553-578. https://doi.org/10.1016/S0301-9322(01)00075-1.

      [8] Jiaccai Lu, Arturo F, Gretan T, (2005), the effect of bubbles on the wall drag in turbulent flow, Physics of Fluids, 17, 095102. https://doi.org/10.1063/1.2033547.

      [9] Mattson, M., Mahesh, K., (2011), Simulation of bubble injection in a turbulent boundary layer, Physics of Fluid, 23, 045107. https://doi.org/10.1063/1.3560382.

      [10] Jackob, B, Oliveri A., Miozzi, MEF, Campana, R. Piva, (2010), Drag reduction by microbubble in a turbulent boundary layer, Physics of Fluid, 22.

      [11] Nandan, A. and Singh, G. (2016) Experimental study of heat transfer rate in a shell and tube heat exchanger with air bubble injection, International Journal of Engineering Transection B: Applications, 29, 1160-1166.

      [12] D.Q. Kern, Process Heat Transfer, McGraw-Hills, New York, 1950.

      [13] Baghban, S.N., Moghiman, M. and Salehi, E., (2000), Thermal analysis of shell-side flow of shell-and tube heat exchanger using experimental and theoretical methods, International Journal of Engineering, 13, 15-26.

      [14] Aghabozorg, M.H., Rashidi, A. and Mohammadi, S., (2016), Experimental investigation of heat transfer enhancement of Fe2O3-cnt/water magnetic nanofluids under laminar, transient and turbulent flow inside a horizontal shell and tube heat exchanger, Experimental Thermal and Fluid Science, 72, 182-189. https://doi.org/10.1016/j.expthermflusci.2015.11.011.

      [15] Fotukian, SM, Esfahany MN, (2010) Experimental study of turbulent convective heat transfer and pressure drop of dilute CuO/water nanofluid inside a circular tube, International Communications in Heat and Mass Transfer 37, 214–219 https://doi.org/10.1016/j.icheatmasstransfer.2009.10.003.

      [16] Yajie R, Huaqing Xie and An C, (2005) Effective thermal conductivity of nanofluids containing spherical nanoparticles, Journal of Physics D: Applied Physics, 38, 3958–3961. https://doi.org/10.1088/0022-3727/38/21/019.

      [17] Sundar LS, Farooky MH, Sarada SN, Singh MK, (2013) Experimental thermal conductivity of ethylene glycol and water mixture based low volume concentration of Al2O3 and CuO nanofluids, International Communications in Heat and Mass Transfer, 41 41–46. https://doi.org/10.1016/j.icheatmasstransfer.2012.11.004.

      [18] K. RP, Suganthi KS, Rajan, K.S., (2012), Transport properties of ultra-low concentration CuO–water nanofluids containing non-spherical nanoparticles, International Journal of Heat and Mass Transfer, 55 4734–4743. https://doi.org/10.1016/j.ijheatmasstransfer.2012.04.035.

      [19] Xiaohao Wei, Haitao Zhu, Tiantian Kong, Liqiu Wang, "Synthesis and thermal conductivity of Cu2O nanofluids†International Journal of Heat and Mass Transfer 52 (2009) 4371–4374. https://doi.org/10.1016/j.ijheatmasstransfer.2009.03.073.

      [20] Prashant, Gurpreet Singh, Tejiner Pal Singh Sarao, “Experimental Investigation of Heat Transfer Characteristics of Plate Heat Exchanger using Alumina - Water based Nanofluids at Different Orientations†Indian Journal of Science and Technology, Vol 9, No. 48, (2016), 0974-5645.

      [21] Swati Singh, Gurpreet Singh and Amit Singla, “Experimental Studies on Heat Transfer Performance of Double Pipe Heat Exchanger with using Baffles and Nanofluids†Indian Journal of Science and Technology, Vol 9, No. 40 ,(2016), 0974-5645.

      [22] Gaurav Thakur and Gurpreet Singh, experimental investigation of heat transfer characteristics in al2o3 – water based nanofluids operated shell and tube heat exchanger with air bubble injection†International Journal of Mechanical and Production Engineering Research and Development Vol.7, No.4, (2017), 263-274. https://doi.org/10.24247/ijmperdaug201727.

  • Downloads

  • How to Cite

    Thakur, G., & Singh, G. (2017). An experimental investigation of heat transfer characteristics of water based Al2O3 nanofluid operated shell and tube heat exchanger with air bubble injection technique. International Journal of Engineering & Technology, 6(4), 83-90. https://doi.org/10.14419/ijet.v6i4.7881