A Comparative Study of Flat Slabs Using Different Shear Reinforcement Parameters

  • Authors

    • N Girish
    • N Lingeshwaran
    2018-04-18
    https://doi.org/10.14419/ijet.v7i2.20.16725
  • Flat slab, Punching shear, Shearbands, Shear reinforcement, Shear stirrups.
  • Punching shear failure is a brittle failure and it is one of the most important types of failure to be considered while designing a reinforced concrete flat slab. This paper aims to study the performance of reinforced concrete flat slabs equipped with different punching shear reinforcement parameters. Three flat slab specimens were cast where two specimens contain punching shear reinforcement in the form of shear stirrups and structural shearbands. The test specimens have length and width of 1000mm and thickness of 185mm for the slabs. The slabs are connected to a column at the center with length and breadth of 300mm and a depth of 700mm. The test specimens were supported by steel plates with length and breadth of 150mm and a thickness of 25mm at the four corners of the slab. The test specimens are loaded on the column face at the top. The deflection, strain and crack pattern were observed and recorded.

     

     

  • References

    1. [1] N. Subramanian, “Alternative punching shear reinforcement for RC flat slabs,†Indian Concrete Journal, vol. 88, no. 1. pp. 33–44, 2014.

      [2] Bureau of Indian Standard(BIS), “Plain and Reinforced Concrete - Code of Practice,†IS 456(4th rev.), no. July, p. New Delhi, India, 2000.

      [3] K. Pilakoutas and X. Li, “Alternative shear reinforcement for reinforced concrete flat slabs,†J. Struct. Eng., vol. 129, no. 9, pp. 1164–1172, 2003.

      [4] IS 10262, “Recommended Guidelines for Concrete Mix Design,†Indian Stand. Bur. Indian Stand., vol. 1982, 2009.

      [5] K. N. Mate and P. S. Patil, “Study of Flat Slab,†vol. 4, no. 6, pp. 1106–1110, 2015.

      [6] R. T. S. Mabrouk, A. Bakr, and H. Abdalla, “Effect of flexural and shear reinforcement on the punching behavior of reinforced concrete flat slabs,†Alexandria Eng. Journal., vol. 56, no. 4, pp. 591–599, 2017.

      [7] D. D. Ivan Duvnjak, Marko Bartolac, “Punching strength of flat slabs with and without shear reinforcement,†ACI Struc. J., vol. 108, no. 2, pp. 197–205, 2011.

      [8] S. S. Patil and R. A. Sigi, “Flat Slab Construction in India,†vol. 3, no. 10, pp. 138–141, 2014.

      [9] J. J. Patel and N. Dubey, “Comparison of Analysis Methods of Flat Slab,†vol. 2, no. 12, pp. 459–463, 2016.

      [10] N. Subramanian, “Design of reinforced concrete structuresâ€, Oxford university press(2016).

  • Downloads

  • How to Cite

    Girish, N., & Lingeshwaran, N. (2018). A Comparative Study of Flat Slabs Using Different Shear Reinforcement Parameters. International Journal of Engineering & Technology, 7(2.20), 321-325. https://doi.org/10.14419/ijet.v7i2.20.16725