Grounded Impedance Simulator Topologies Employing Minimum Passive Elements

  • Authors

    • Mohammad Faseehuddin
    • Jahariah Sampe
    • Sawal Hamid Md Ali
    2018-05-16
    https://doi.org/10.14419/ijet.v7i2.28.12871
  • Current Mode, Capacitors, Current conveyor, Inductors, Simulators, Tunability

  • In this research three new grounded inductance simulators (GIS) are proposed. In addition, frequency dependent negative resistor (FDNR) and grounded capacitor (GC) simulators are also developed. The voltage differencing current conveyor (VDCC) is utilized in the design. All the developed simulator circuits need a single active block and only two grounded passive components. All the designed simulator circuits are perfectly tunable and did not suffer from passive component matching constraints. To demonstrate the performance of the inductor, FDNR and GC circuits they are employed in designing  current mode parallel RLC multifunction filter, low pass third order Butterworth filter and RLC resonance circuits. The VDCC is designed in 0.18μm CMOS technology parameters from TSMC and simulated in P-Spice software to prove the theoretical predictions.

     

  • References

    1. [1] M. A. İbrahim, S. Minaei, E. Yüce, N. Herencsar & J. Koton, Lossy/lossless floating/grounded inductance simulation using one DDCC, Radioengineering, 21, (2014), 3-10.

      [2] F. Mohammad, J. Sampe, S. Shireen & S. H. M. Ali, Minimum passive components based lossy and lossless inductor simulators employing a new active block, AEU-International Journal of Electronics and Communications, 82, (2017), 226-240.

      [3] J. Sampe, N. A. A. Semsudin, F. F. Zulkifli, M. S. Islam & M. Z. Ab Razak, Hybrid energy harvester based on radio frequency, thermal and vibration inputs for biomedical devices, Asian Journal of Scientific Research, 10, (2017), 79-87.

      [4] F. F. Zulkifli, J. Sampe, M. S. Islam & M. A. Mohamed, Architecture of ultra low power micro energy harvester using RF signal for health care monitoring system: A review, American Journal of Applied Sciences, 12, (2015), 335-344.

      [5] M. Kiranmayi & A. Kathirvel, Underwater wireless sensor networks: applications, challenges and design issues of the network layer-a review, International Journal of Emerging Trends in Engineering Research, 3, (2015), 05-11.

      [6] M. Faseehuddin, J. Sampe & M. S. Islam, Designing ultra low voltage low power active analog blocks for filter applications utilizing the body terminal of MOSFET: A review, Asian Journal of Scientific Research, 9, (2016), 106-121.

      [7] E. Yuce & S. Minaei, On the realization of simulated inductors with reduced parasitic impedance effects, Circuits, Systems, and Signal Processing, 28, (2009), 451-465.

      [8] F. Kaçar & H. Kuntman, New realization of FDNR and sixth order band pass filter application, 20th European Conference on Circuit Theory and Design (ECCTD), (2011), 381-384.

      [9] F. Kacar, B. Metin & H. Kuntman, A new CMOS dual-X second generation current conveyor (DXCCII) with an FDNR circuit application, AEU-International Journal of Electronics and Communications, 64, (2010), 774-778.

      [10] A. Jantakun, A simple grounded FDNR and capacitance simulator based-on CCTA, AEU-International Journal of Electronics and Communications, 69, (2015), 950-957.

      [11] P. Prommee & M. Somdunyakanok, CMOS-based current-controlled DDCC and its applications to capacitance multiplier and universal filter, AEU-International Journal of Electronics and Communications, 65, (2011), 1-8.

      [12] A. Gupta, R. Senani, D. R. Bhaskar & A. K. Singh, OTRA-based grounded-FDNR and grounded-inductance simulators and their applications, Circuits, Systems, and Signal Processing, 31, (2012), 489-499.

      [13] A. Yeşil, F. Kaçar & K. gürkan, Lossless grounded inductance simulator employing single VDBA and its experimental band-pass filter application, AEU-International Journal of Electronics and Communications, 68, (2014), 143-150.

      [14] A. Kartci, U. E. Ayten, N. Herencsar, R. Sotner, J. Jerabek & K. Vrba, Application possibilities of VDCC in general floating element simulator circuit, In IEEE European Conference on Circuit Theory and Design ECCTD, (2015),1-4.

      [15] E. Yuce, S. Minaei & O. Cicekoglu, A novel grounded inductor realization using a minimum number of active and passive components, Etri Journal, 27, (2005), 427-432.

      [16] F. Kaçar & A. Yeşil, FDCCII-based FDNR simulator topologies, International Journal of Electronics, 99, (2012), pp. 285-293.

      [17] G. Ferri, N. C. Guerrini & M. Diqual, CCII-based floating inductance simulator with compensated series resistance, Electronics Letters, 39, (2003), 1560-1562.

      [18] M. T. Abuelma'atti & N. A. Tasadduq, Electronically tunable capacitance multiplier and frequency-dependent negative-resistance simulator using the current-controlled current conveyor, Microelectronics Journal, 30, (1999), 869-873.

      [19] I. Myderrizi & A. Zeki, Electronically tunable DXCCII-based grounded capacitance multiplier, AEU-International Journal of Electronics and Communications, vol. 68, (2014), 899-906.

      [20] M. O. Cicekoglu, Active simulation of grounded inductors with CCII+s and grounded passive elements, International Journal of Electronics, 85, (1988), 455-462.

      [21] A. Lahiri & M. Gupta, Realizations of grounded negative capacitance using CFOAs, Circuits, Systems, and Signal Processing, 30, (2011), 143-155.

      [22] E. Yuce & S. Minaei, A modified CFOA and its applications to simulated inductors, capacitance multipliers, and analog filters, IEEE Transactions on Circuits and Systems I: Regular Papers, 55, (2008), 266-275.

      [23] J. Koton, B. Metin, N. Herencsar & J. W. Horng, DCCII-based novel lossless grounded inductance simulators with no element matching constrains, Radioengineering, 23, (2014), 532-539.

      [24] E. Yuce & O. Cicekoglu, The effects of non-idealities and current limitations on the simulated inductances employing current conveyors, Analog Integrated Circuits and Signal Processing, 46, (2006), 103-110.

      [25] F. Kaçar, A. Yeşil, S. Minaei & H. Kuntman, Positive/negative lossy/lossless grounded inductance simulators employing single VDCC and only two passive elements, AEU-International Journal of Electronics and Communications, 68, (2014), 73-78.

      [26] R. Senani, A simple approach of deriving Single-input-multiple-output current-mode biquad filters, Frequenz: Journal of Telecommunications, 50, (1996), 124-127.

  • Downloads

  • How to Cite

    Faseehuddin, M., Sampe, J., & Hamid Md Ali, S. (2018). Grounded Impedance Simulator Topologies Employing Minimum Passive Elements. International Journal of Engineering & Technology, 7(2.28), 1-5. https://doi.org/10.14419/ijet.v7i2.28.12871